How to install transition strips



How to install transition strips on to concrete floors:





        1. Clean the floor with a wire brush or stiff broom. Cleaner floors provide better bonds
        2. Assemble cartridge (Remove plugs and attach static mixer prior to use).
        3. Apply one or two beads of material to the floor, depending on width of the molding and the surface texture of the floor.
        4. Set the molding into place. Do not allow more than a few minutes of open time.
        5. An electric heat gun may be used to accelerate the cure in colder temperatures.
        6. Clean up excess material as soon as possible with a clean rag. Cured material may be removed with MEK or acetone.